Translations of this page:
User Tools
Sidebar
tutorials:plen2:body
Table of Contents
Body
Table of Contents
Parts List
Parts list of the body is enumerated below.
| Name | Q'ty |
|---|---|
| body_middle.stl | 1 |
| servo_bracket.stl | 2 |
| servo_bracket_mirror.stl | 2 |
| servo_fixer.stl | 1 |
| Servo Motor (Length A) | 2 |
| Servo Motor (Length B) | 2 |
| Low Head Screw | 4 |
| Screw | 2 |
| Finished Head | 1 |
| Control Board with Power Supply | 1 |
Print Detail
Assembling Process
Parts List
Attach Servos
Attention!: Servos' cables are passed through inside the body's gap.
Attach the Finished Head
Attention!: Head-board's cable is passed through inside the body's gap.
Attach Spacer for Servos
Attach the Control Board
Attention!: Control-board's cable is passed through inside the body's gap.
Attention!: Please use normal screws to attach the control-board.
Attach the Brackets
Attention!: Before to attach the brackets, you should connect servos' cables and the control-board. When it was completed, please turn on both switches and keep the status.
Attention!: Please connect the white wire which is owned by a servo to inside of the control-board.
Attention!: Attach a servo-bracket to the body. At that time, please check it is placed approximately parallel to edge of the body.
Attention!: Attach a servo-bracket (mirror) to the body. At that time, please check it is placed approximately parallel to edge of the body.
Attention!: Attach a servo-bracket to the body. At that time, please check it is placed approximately parallel to edge of the body.
Attention!: Attach a servo-bracket (mirror) to the body. At that time, please check it is placed approximately parallel to edge of the body.
Finished Body
tutorials/plen2/body.txt · Last modified: 2021/04/01 13:52 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
