User Tools

Site Tools


tutorials:plen2:body

This is an old revision of the document!


Body

Table of Contents

Parts List

Parts list of the body is enumerated below.

Name Q'ty
body_middle.stl 1
servo_bracket.stl 2
servo_bracket_mirror.stl 2
servo_fixer.stl 1
Servo Motor (50mm) - Length A 2
Servo Motor (130mm) - Length B 2
Low Head Screw 4
Screw 2
Finished Head 1
Control Board with Power Supply 1

Assembling Process

Parts List

Attach Servos

Attention!: Servos' cables are passed through inside the body's gap.

Attach the Finished Head

Attention!: Head-board's cable is passed through inside the body's gap.

Attach Spacer for Servos

07_attach_spacer.jpg

Attach the Control Board

Attention!: Control-board's cable is passed through inside the body's gap.

Attention!: Please use normal screws to attach the control-board.

Attach the Brackets

Attention!: Before to attach the brackets, you should connect servos' cables and the control-board. When it was completed, please turn on both switches and keep the status.

Attention!: Please connect the white wire which is owned by a servo to inside of the control-board.

Attention!: Attach a servo-bracket to the body. At that time, please check it is placed approximately parallel to edge of the body.

Attention!: Attach a servo-bracket (mirror) to the body. At that time, please check it is placed approximately parallel to edge of the body.

Attention!: Attach a servo-bracket to the body. At that time, please check it is placed approximately parallel to edge of the body.

Attention!: Attach a servo-bracket (mirror) to the body. At that time, please check it is placed approximately parallel to edge of the body.

Finished Body

22_complete.jpg


Prev < Head
Next > Merge the Parts

tutorials/plen2/body.1460253988.txt.gz · Last modified: 2016/04/10 02:06 by Guvalif