You are not logged in.
Pages: 1
Dear All :
I did all 8 steps
Still not work, once I power on.
Is anypossible because I use ES08MD II causing this issue ?
Or any configure file I need to check again ?
Dear Sir :
I have problem to "reset all" in control server(ControlServer_Win_v2.4.0) to let PLEN2 Stand straight , once I connect power on.
I also press the HOME button, the position is not set to right position, if I power on again.
My environment: plen-Firmware_Arduino-1.4.1 -> OK
servo : ES08MD II
Just buy from Japan: 1x PLEN2 Control Board ; 1x PLEN2 Head Board (Bluetooth SMART Module; Six-axis Sensor (Gyro + Accelerometer)
What file I need to modify or any setting I need to adjust ?
Pages: 1