This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
tutorials:plen2:arm [2016/03/23 04:58] Guvalif |
tutorials:plen2:arm [2021/04/01 13:52] (current) |
||
---|---|---|---|
Line 19: | Line 19: | ||
Parts list of the left arm is enumerated below. (Also you could use the parts to build the right arm.) | Parts list of the left arm is enumerated below. (Also you could use the parts to build the right arm.) | ||
- | ^Name ^ Q' | + | ^Name |
- | |[[https:// | + | |[[https:// |
- | |[[https:// | + | |[[https:// |
- | |[[https:// | + | |[[https:// |
- | |[[https:// | + | |[[https:// |
- | |[[https:// | + | |[[https:// |
- | |Servo Motor (160mm) | + | |Servo Motor (Length C) |
- | |Servo Motor (180mm) | + | |Servo Motor (Length D) |
+ | |||
+ | {{ : | ||
Line 47: | Line 49: | ||
==== Hand ==== | ==== Hand ==== | ||
+ | **Attention!**: | ||
+ | If you assemble plastic cast parts, this step has already been completed. | ||
+ | |||
{{: | {{: | ||
{{: | {{: | ||
Line 64: | Line 69: | ||
**Attention!**: | **Attention!**: | ||
- | Attach a servo-horn to 180[mm] | + | Attach a servo-horn to length D servo. At that time, please check it is placed approximately parallel to edge of the servo. |
{{: | {{: |