PLEN Playground - Forum

anzenbp

Member

Registered: 2016-06-17

Posts: 5

Connect PLEN2 with Windows 10

1) I start ControlServer Win V2.0.1
2) I connect the robot with my notebook via usb
3) the eyes (leds) light and blink
4) I press the button "connect" in the "PLENUtilities for Web" running on "http://localhost:17264/"
5) I get the message: "USB connection has been disconnected!"

What's wrong? an you help me?

Sincerely,
Peter

Guvalif

Moderator

From: Osaka / Japan

Registered: 2015-08-31

Posts: 135

Website

Re: Connect PLEN2 with Windows 10

Hi, anzenbp

Just for confirmation, Have you install Arduino IDE released by arduino.cc?
I think the issue was caused by there is no device driver for Arduino Micro.

anzenbp

Member

Registered: 2016-06-17

Posts: 5

Re: Connect PLEN2 with Windows 10

Hi Guvalif,
no, I did not. Where can I get and which version I will need? Is that all I need? I am not familar with the PLEN2, I just start trying it out.

Guvalif

Moderator

From: Osaka / Japan

Registered: 2015-08-31

Posts: 135

Website

Re: Connect PLEN2 with Windows 10

OK, let you download following one:
https://www.arduino.cc/en/Main/Software

DaisukeH

Member

Registered: 2017-08-11

Posts: 1

Re: Connect PLEN2 with Windows 10

I had a same probrem.

I installed arduino IDE 1.8.3 for "windows store app".

1) I start ControlServer Win V2.4.0
2) I connect the robot with my notebook via usb
3) the eyes (leds) light and blink
4) I press the button "connect" in the "PLENUtil" running on "http://localhost:17264/"
5) I get the message: "USB connection has been disconnected!"

I unistalled windows store version's arduino IDE.
And Installed windows exe vresion's arduino IDE 1.8.3.

During installing, usb device driver installed, and can connect ControlServer.