PLEN Playground - Forum

John

Member

Registered: 2015-10-14

Posts: 4

Assembling instruction

Hello.

I have some suggestions for assempling instructions wiki:

Add to Body instruction
- in parts list: a Battery
- add to a first foto: servo_bracket_type1* for legs, battery
- move a foto with attaching servo_bracket_type1 from Merge fo Body and on the Merge page just attach arms and legs to body
- add foto with assembling battery
Add to Head instruction
- in parts list and on foto - neck_rev2
Optional: remove from Arms and Legs foto of parts servo_bracket_type1, because it not in parts list.

And what to do with parts:
- chest_0_05.stl
- body_middle_test.stl
- servo_horn_rev1_through_hole.stl

Guvalif

Moderator

From: Osaka / Japan

Registered: 2015-08-31

Posts: 135

Website

Re: Assembling instruction

Hi, John

Thanks for your suggestions! It may also take a little while, but we will think about it :)

yamaura

Member

Registered: 2015-09-05

Posts: 4

Re: Assembling instruction

Hi Guvalif,
I also want to ask about assembling instruction.

The instruction says we should use 2 servo_assem_type2.stl for right leg.
However, I think we should use servo_assem_type2.stl and servo_assem_type2_mirror.stl.
This picture apparently uses mirrored parts.

Is it right?

右足用にservo_assem_type2.stlを二つ使うと書いてあるのですが、
servo_assem_type2.stlとservo_assem_type2_mirror.stlではないでしょうか？

Last edited by yamaura (2016-02-14 12:08:34)

Guvalif

Moderator

From: Osaka / Japan

Registered: 2015-08-31

Posts: 135

Website

Re: Assembling instruction

Hi, yamaura

That's right you intended! Thanks for reporting the mistake :)