PLEN Playground - Forum

John

Member

Registered: 2015-10-14

Posts: 4

Print Details

Hello.

Could you add on Specification page topic about print details for Head and Body parts like for Arms and Legs?
And for arms/legs could you check parts or explain using of servo_horn_rev1_through_hole.stl? It is not in table.

thank you.
P.S. I recieved my "PLEN2 Control boards (Arduino compatible) & servo motors set" on Monday. Now i looking for print details for order 3D print.

Guvalif

Moderator

From: Osaka / Japan

Registered: 2015-08-31

Posts: 135

Website

Re: Print Details

Hi, John

We have no plans to give users print details for Head and Body at this point in time, because we hope that we make the manual after to develop has finished perfectly, but those are under development now, so please be looking forward.

Print detail for servo_horn_rev1_through_hole.stl is defined same as ones which servo_horn_rev1.stl has.

Last edited by Guvalif (2015-11-20 10:11:12)