User Tools
specifications:print_detail:head
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
specifications:print_detail:head [2016/01/12 05:21] PLEN Project Committee |
specifications:print_detail:head [2016/11/22 08:24] (current) Guvalif |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Head ====== | ====== Head ====== | ||
| + | |||
| + | ===== Table of Contents ===== | ||
| + | * [[arms]] | ||
| + | * [[legs]] | ||
| + | * [[head]] **Current section** | ||
| + | * [[body]] | ||
| + | |||
| + | ---- | ||
| ===== Overview ===== | ===== Overview ===== | ||
| + | ^ 3D Printer Used ^ Print Region ^ | ||
| + | | Afinia H480 | Head | | ||
| + | | {{h480.jpg?nolink}} | {{.head:region.jpg?nolink}} | | ||
| - | ^ 3D Printer Used ^ Print Region ^ | ||
| - | | Afinia H480 | Head | | ||
| - | | {{h480.jpg?direct}} | {{head_assem.jpg?direct&350}} | | ||
| ===== Files that Need to Print ===== | ===== Files that Need to Print ===== | ||
| + | ==== head.stl ==== | ||
| + | ^ Q'ty ^ Z Resolution ^ Part Angle ^ Fill ^ Support Angle ^ Quality ^ Time ^ | ||
| + | | 1 | 0.15 [mm] | 30 [deg.] | Loose | 30 [deg.] | Fine | 2h 34m | | ||
| + | |||
| + | === Placement & Result === | ||
| + | {{.head:placement:head.jpg?nolink}} | ||
| + | {{.head:result:head.jpg?nolink}} | ||
| - | ^ servo_horn_rev1.stl ^^^^^^^ | ||
| - | ^ Q'ty ^ Placement ^ Z Resolution ^ Fill ^ Quality ^ Output Time ^ Print Result ^ | ||
| - | | 10 | {{servo_horn_rev1.stl.placement.png?direct&120}} | 0.15 [mm] | Solid | Fine | 4 [min.] | {{head_a.jpg?direct&120}} | | ||
| - | ^ servo_bracket_type1.stl ^^^^^^^ | + | ==== chin.stl ==== |
| - | ^ Q'ty ^ Placement ^ Z Resolution ^ Fill ^ Quality ^ Output Time ^ Print Result ^ | + | ^ Q'ty ^ Z Resolution ^ Part Angle ^ Fill ^ Support Angle ^ Quality ^ Time ^ |
| - | | 1 | {{servo_bracket_type1.stl.placement.png?direct&120}} | 0.15 [mm] | Solid | Fine | 31 [min.] | {{barb.jpg?direct&120}} | | + | | 1 | 0.15 [mm] | 30 [deg.] | Loose | 10 [deg.] | Normal | 1h 22m | |
| + | === Placement & Result === | ||
| + | {{.head:placement:chin.jpg?nolink}} | ||
| + | {{.head:result:chin.jpg?nolink}} | ||
specifications/print_detail/head.1452576076.txt.gz · Last modified: 2016/01/12 05:21 by PLEN Project Committee
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
