This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
tutorials:plen2:leg [2016/02/26 04:47] Guvalif created |
tutorials:plen2:leg [2021/04/01 13:52] (current) |
||
---|---|---|---|
Line 12: | Line 12: | ||
- [[tune]] | - [[tune]] | ||
- | Prev > [[arm]]\\ | + | Prev < [[arm]]\\ |
Next > [[head]] | Next > [[head]] | ||
---- | ---- | ||
Line 20: | Line 20: | ||
If you would like to assemble the right leg, please use parts which have ' | If you would like to assemble the right leg, please use parts which have ' | ||
- | ^Name ^ Q' | + | ^Name |
- | |[[https:// | + | |[[https:// |
- | |[[https:// | + | |[[https:// |
- | |[[https:// | + | |[[https:// |
- | |[[https:// | + | |[[https:// |
- | |[[https:// | + | |[[https:// |
- | |[[https:// | + | |[[https:// |
- | |[[https:// | + | |[[https:// |
- | |[[https:// | + | |[[https:// |
- | |Servo Motor (130mm) | + | |Servo Motor (Length B) |
- | |Servo Motor (160mm) | + | |Servo Motor (Length C) |
- | |Servo Motor (180mm) | + | |Servo Motor (Length D) |
+ | |||
+ | {{ : | ||
Line 62: | Line 64: | ||
==== Lower Foot ==== | ==== Lower Foot ==== | ||
+ | **Attention!**: | ||
+ | If you assemble plastic cast parts, this step has already been completed. | ||
+ | |||
{{: | {{: | ||
{{: | {{: | ||
Line 75: | Line 80: | ||
Please connect the white wire which is owned by a servo to inside of the control-board. | Please connect the white wire which is owned by a servo to inside of the control-board. | ||
- | {{: | + | {{ : |
+ | {{ : | ||
**Attention!**: | **Attention!**: | ||
Line 95: | Line 101: | ||
**Attention!**: | **Attention!**: | ||
- | In merging the left shin and the left upper foot, please pass through inside | + | In merging the left shin and the left upper foot, servos' |
{{: | {{: | ||
Line 109: | Line 115: | ||
---- | ---- | ||
- | Prev > [[arm]]\\ | + | Prev < [[arm]]\\ |
Next > [[head]] | Next > [[head]] |