Differences

This shows you the differences between two versions of the page.

--- tutorials:plen2:firmware [2016/04/16 11:57]
Guvalif
+++ tutorials:plen2:firmware [2021/04/01 13:52]
@@ Line 1: / Line 1: @@
-====== Firmware Installation ======
-===== Table of Contents =====
-  - [[firmware]] **Current section**
-  - [[battery]]
-  - [[arm]]
-  - [[leg]]
-  - [[head]]
-  - [[body]]
-  - [[merge]]
-  - [[cover]]
-  - [[tune]]
-Next > [[battery]]
-----
-===== Before You Install the Firmware =====
-If you bought excepting loose selling control board, the firmware was already installed.
-You can skip this step and do next step.
-===== Preliminary Arrangements =====
-To write PLEN2's firmware requires Arduino IDE **ver.1.6.0 or later**.
-Please download and install it before to do continued steps.
-===== Installation Process =====
-Download [[https://github.com/plenproject/PLEN2|"PLEN2"]] repository.
-{{:tutorials:plen2:firmware:01_download_f.png?direct}}
-Open "firmware.ino" (This is placed "/arduino/firmware/" directory) with Arduino IDE.
-{{:tutorials:plen2:firmware:02_open_f.png?direct}}
-Choose target board as "Arduino/Genuino Micro".
-{{:tutorials:plen2:firmware:03_choose_f.png?direct}}
-Take proper serial port to communicate your base-board.
-**(Port name is different in each environments.)**
-{{:tutorials:plen2:firmware:04_take_f.png?direct}}
-Click upload button.
-{{:tutorials:plen2:firmware:05_upload_f.png?direct}}
-----
-Next > [[battery]]

PLEN Playground - Wiki