This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
tutorials:plen2:arm [2015/10/15 13:55] roknk created |
tutorials:plen2:arm [2021/04/01 13:52] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== | + | ====== |
===== Table of Contents ===== | ===== Table of Contents ===== | ||
- | - [[introductions]] | + | - [[firmware]] |
- | - [[arms]] **現在位置** | + | - [[battery]] |
- | - [[legs]] | + | - [[arm]] **Current section** |
- | - [[fuselage]] | + | - [[leg]] |
- [[head]] | - [[head]] | ||
- | - [[marge]] | + | - [[body]] |
+ | - [[merge]] | ||
+ | - [[cover]] | ||
+ | - [[tune]] | ||
- | Prev > [[introductions]] | + | Prev < [[battery]]\\ |
- | Next > [[arm]] | + | Next > [[leg]] |
---- | ---- | ||
+ | |||
+ | ===== Parts List ===== | ||
+ | Parts list of the left arm is enumerated below. (Also you could use the parts to build the right arm.) | ||
+ | |||
+ | ^Name | ||
+ | |[[https:// | ||
+ | |[[https:// | ||
+ | |[[https:// | ||
+ | |[[https:// | ||
+ | |[[https:// | ||
+ | |Servo Motor (Length C) | ||
+ | |Servo Motor (Length D) | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | |||
+ | ===== Print Detail ===== | ||
+ | [[specifications/ | ||
+ | |||
+ | |||
+ | ===== Assembling Process ===== | ||
+ | ==== Parts List ==== | ||
+ | {{: | ||
+ | |||
+ | ==== Upper Arm ==== | ||
+ | {{: | ||
+ | {{: | ||
+ | |||
+ | **Attention!**: | ||
+ | Please fit the conducting wire through inside a groove on **servo_assem_type1.stl**. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | ==== Hand ==== | ||
+ | **Attention!**: | ||
+ | If you assemble plastic cast parts, this step has already been completed. | ||
+ | |||
+ | {{: | ||
+ | {{: | ||
+ | |||
+ | ==== Merge Parts ==== | ||
+ | **Attention!**: | ||
+ | Before to merge the parts, you should connect servos' | ||
+ | When it was completed, please turn on both switches and keep the status. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | **Attention!**: | ||
+ | Please connect the white wire which is owned by a servo to inside of the control-board. | ||
+ | |||
+ | {{ : | ||
+ | {{ : | ||
+ | |||
+ | **Attention!**: | ||
+ | Attach a servo-horn to length D servo. At that time, please check it is placed approximately parallel to edge of the servo. | ||
+ | |||
+ | {{: | ||
+ | {{: | ||
+ | |||
+ | ==== Finished Arm ==== | ||
+ | {{: | ||
+ | |||
+ | ---- | ||
+ | Prev < [[battery]]\\ | ||
+ | Next > [[leg]] |